Instructions for use toning after striping

Toning after streaks:

If the tint is to be applied all the way to the scalp, the tint must always be applied to slightly damp hair after washing.

Mixture Toning small:
1 bottle N:2 h2o2 0.9% 90ml with 2 tubes N:3 Mix.

Mixing Toning medium:
1 bottle of N:2 h2o2 0.9% 90ml with 3 tubes of N:3 Mix + 30 ml of cold water.

Toning Procedure:

Application: Start applying the tint to slightly damp hair. It is important that the hair is damp, otherwise your hair between the streaks will get a lightening effect. Start at the back and work your way towards the face, and always end with the thin, fine hairs towards the face. Very important that the toning only Apply to the inside of newly streaked regrowth from the start. Lengths and ends absorb color quickly and can thus become darker. Lengths and ends can be foamed up just for a nice refresh.

Operating time: 30min at the bottom. A tint will always make the hair a little darker as it does not contain any form of lightening. You can comb a little right at the transition or pull the tint a little further out towards the end of the exposure time. Lengths and ends will always absorb color much faster than the hair towards the scalp. Always think that the hair that is the most golden needs the most neutralization.

Refresh the color at the ends:
Rinse hair with about 2-4 dl of water, then lather the toner like a shampoo. You can leave it on for 1-5 minutes before rinsing out.

Wash your hair thoroughly with shampoo twice and finish with a good conditioner or hair treatment.