Instructions for use Stripes & Toning

Stripes and toning:

Preparation:
Your hair does not need to be freshly washed before stripping, but it is important that you do not have dry shampoo or color spray in your hair.

Striping procedure

Mixing ratio and application:
1 bag Blond + 1 bottle H2o2 = mix together. Always mix only one mixture at a time. Apply to dry hair and always start with the darkest hair. The hair around the face is thinner and finer, so it will lighten faster.

Operating time: Full exposure time is 60min, after 60min the lightening decreases significantly. It is important that you check the lightness of the strips before rinsing. It is important to leave in long enough and not rinse too soon. Our bleaching is gentle and we always recommend a lower strength of bleaching and full exposure time.

Flushing:
Rinse thoroughly, shampoo once, and apply conditioner or hair treatment to lengths and ends. Towel dry hair before toning.

If you are going to strip your entire hair, the 2-3 cm from the scalp will always lighten more due to the heat from the scalp. If the hair is equally dark all over and the hair quality is good, you can choose an equal H202 from root to tip. If you have lighter lengths, choose a weaker strength for them rather than the regrowth. It is always important to have good hair quality when you are going to strip your entire hair.

Mixture Toning small:
1 bottle N:2 h2o2 0.9% 90ml with 2 tubes N:3 Mix.

Mixing Toning medium:
1 bottle of N:2 h2o2 0.9% 90ml with 3 tubes of N:3 Mix + 30 ml of cold water.

Toning Procedure:

Application: Start applying the tint to slightly damp hair. It is important that the hair is damp, otherwise your hair between the streaks will get a lightening effect. Start at the back and work your way towards the face, and always end with the thin, fine hairs towards the face. Very important that the toning only Apply to the inside of newly streaked regrowth from the start. Lengths and ends absorb color quickly and can thus become darker. Lengths and ends can be foamed up just for a nice refresh.

Operating time: 20-30min at the bottom. A tint will always make the hair a little darker as it does not contain any form of lightening. You can comb a little right at the transition or pull the tint a little further out towards the end of the working time. Lengths and ends will always absorb color much faster than the hair towards the scalp. Always think that the hair that is most golden needs more neutralization, if you have lengths that are already completely light, these do not need any form of neutralization.

Refresh the color at the ends:
Rinse hair with about 2-4 dl of water, then lather the toner like a shampoo. You can leave it on for 1-5 minutes before rinsing out.

Wash your hair thoroughly with shampoo twice and finish with a good conditioner or hair treatment.

Lather up the color in the lengths for a nice refresh:

Bleaching & Toning with less blending