Instructions for use Light color and correction by Bente

This is a perfect treatment if you want to be blonde, but at the same time have some gray to cover. Or if you found it easier to work with color rather than bleaching. A bleaching will always give a lighter result than a light color. The hair does not need to be freshly washed as the fat layer on the scalp provides protection. Having a friend who can help you with the application can often improve the result.

This is a two-step process, as you dye your hair in 2 rounds.

Step 1:
Light color – Mix H2O2 90ml with Mix x 2 tubes. Here you should use a strong strength of h2o2 to achieve the effect.

Step 2:
Correction – Mix H2O2 60ml with Mix x 2 tubes. Permanent hair color is used for correction. Here we usually recommend using 3% as this will neutralize without darkening the hair.

Procedure:
Apply lightening color to dry hair. Start with the darkest hair and work your way towards the face. The hair around the hairline is thinner and finer, and therefore lightens faster. Leave it on for 45 minutes. Then wash your hair with shampoo and dry.

Corrective color is applied to the scalp on dry hair. The color is taken from the entire base, and only pulled out in parts that need neutralization. But always remember that the hair closest to the scalp always needs longer to neutralize than the lengths of the hair. Working time 30 minutes. The hair color does not start to work until it is out of the color bowl, so if you spend a little time on the application, it will not affect the result.

Flushing:
Always rinse your hair well after a color treatment. Wash your hair twice after the last treatment, and finish with a good conditioner or hair treatment.

To refresh the color in the lengths:
Apply or rinse with about 2-4 dl of water over the sections of the hair where the color is, and then lather the color up into the lengths like a shampoo. Leave it on for 2-5 minutes before rinsing everything out.